FramePro Free Download

This article shows you how to download and install the full version of FramePro v1.10.13 for free on a PC. Follow the direct download link and instructions below for guidance on installing FramePro v1.10.13 on your computer.

About the software

Integrate FramePro into your codebase in minutes – simply add FramePro.cpp/h into your code and start adding scopes. Add timing scopes using the supplied macros to any function or block of code. FramePro will then track the time, thread and core of each scope. This scope information will be sent to the FramePro application, where thread and core utilization can be viewed for each frame.

FramePro has minimal overhead. When profiling, the first rule is to not change the behavior of what is being profiled. FramePro allows you to add thousands of timing scopes per frame with no noticeable impact on frame rate.

Profile in real-time. In interactive mode you can see the data as it is being recorded, easily spot a frame rate spike, and immediately zoom in to that frame to find the cause.

No limit to the length of a capture. Unlike many profilers which can only capture a few seconds worth of data, FramePro can capture long play sessions.

Framepro uses the highest resolution timer available on your system. It is configured for many platforms and easily configurable.

FramePro is easy and intuitive to use. Everyone who sees FramePro in action immediately ‘gets it’. FramePro can be used by programmers and non-programmers alike.

The main features of FramePro are:

  • Integrate FramePro into your codebase in minutes
  • FramePro allows you to add thousands of timing scopes per frame with no noticeable impact on frame rate
  • The scope recording code is minimal and consists of only a few instructions
  • FramePro will display the profile data as it is received. You can pause the data and inspect frames at any time while recording.

FramePro v1.10.13 System Requirements

  •  Operating System: Windows 11, Windows 10, Windows 8.1, Windows 7

How to Download and Install FramePro v1.10.13

  1. Click on the download button(s) below and finish downloading the required files. This might take from a few minutes to a few hours, depending on your download speed.
  2. Extract the downloaded files. If you don’t know how to extract, see this article. The password to extract will always be:
  3. Run FramePro_x64_setup.exe and install the software.
  4. Run Patch.exe from the Patch folder and apply the patch.
  5. You now have the full version of FramePro v1.10.13 (x64) installed on your PC.

Required files

File #1 (19.8 MB)


How do you rate this post?

Click on a star to rate it!

Average rating 0 / 5. Vote count: 0

No votes so far! Be the first to rate this post.